Pyle PWMA850UFM User Manual

Operating Instructions
Confirm Power
1. AC Power: Before operation, confirm that the voltage provided is the
same as the voltage indicated by the power switch and label. If it is
not, the unit will be damaged.
Built-in rechargeable battery: If the battery is charged, it is
unnecessary to plug the unit to a wall outlet for use.
When the Low Voltage Indicator lights up, please charge the battery.
When the Full Voltage Indicator lights up, the unit is fully charged.
If the unit will not be used for an extended period of time, please
recharge the battery every 2 months for 8-10 hours at a time.
Operation
Plug the power cable into the socket and connect it
with the amplifier system.
. Turn on the amplifier. The red LED Power Indicator should light up.
When charging, the recharge indicator will flash continuously. When
the battery is full, the Indicator light will no longer flash.
Music can be played while charging.
. To turn on the wireless mic insert two AA 1.5V batteries into the unit.
Set the power switch to the middle. The power indicator should flash
once. The RD indicator should light up green.
Set the power switch on the handheld mic to the ON position. You
will be able to hear sound from the amplifier when speaking. Adjust
the Volume, Echo, Treble, Bass to the proper position to avoid
feedback.
If the power indicator on the microphone is constantly lit, then the
battery is low on power. Consider replacing the battery.
. To connect a guitar: Using an unbalanced 1/4” cable, plug the guitar
into the guitar input jack. The guitar is ready to be played.
Wired Microphone
1. Two-way wired microphone input jack allow for simultaneous use.
2, Plug wired microphones into separate jacks.
3. Adjust Echo controls for preference.
4, Adjust the volume of each microphone to the desired level. If
feedback occurs, lower the volume level.

Pyle PWMA850UFM Specifications

General

Brand	Pyle
Model	PWMA850UFM
Category	Speakers
Language	English