GETTING STARTED
SUP BOARD MR PUMP
Your SUP Board comes with a high pressure pump. This pressure pump, pumps low volume of air with each
pumping motion. It takes longer to fill the board with air, but allows the board to reach a higher air pressure.
This is good for achieving maximum performance from the board.
The SUP board air pump is also lubricated with oil. To ensure the life of the air pump, make sure the pump
is fully lubri-cated before and during each use. To lubricate the pump, simply open the top and place a few
drops of oil/grease on the gasket and tube. Take a second to clean the air filter, also located inside the top
of the pump.
THE PADDLE
Your board paddle comes in three pieces. To build the paddle, hold the button in while sliding the pieces
together until they click into place. The last section (top) of the paddle is adjustable.
To find the ideal height for your paddle, start by building the paddle so it is 6 inches taller than your own
height. From this point, adjust the top section up or down until the length is comfortable for you. A longer
paddle is better suited for a smooth, easier paddling motion. A shorter paddle is good for performance or
competition riding.
5
To Next Page
Loading...
Need help?
General