Pyramid PM-7501 - Microphone and Output Mode Operations

OPERATION
5.USING THE DJ'S MICROPHONE, MIC 1
A TALKOVER switch
a TALK' Set this switch to TALK, all outputs except MIC 1 and MIC 2 are
attenuated. Only your voice can be heard dearly through MIC 1
bAUTO' Set this switch to AUTO MUTE, it is a function of AUTO
TALKOVER all outputs are automatically attenuated as long as you are
speaking
c.QFF. When not using MIC 1, set this switch to OFF, all Outputs return to
same level. This method is useful when paging
B BASS and TREBLE Tone controls
you can tailor the high and low frequency sounds of MIC 1 processed
through the mix to fit the acoustic surroundings and your personal taste
using the BASS or TREBLE tone controls To enhance the sounds, rotate
BASS or TREBLE towards +10. To reduce them, rotate BASS or TREBLE
towards *10 To resume normal sound, set them to the middle position
C. LEVEL control
For a binding of voice and music, adjust the miC i LEVEL to increase or
decrease the microohone level without affecting the main volume incuts
Set MIC 1 LEVEL to 0 when not using the DJ'S microphone.
6 USING MONO/ STEREO
When you set MONO/STEREO to MONO, the mixer combines the left and
right channels then sends the signals to OUTPUT R and L jacks. The
combined output signals can be used by a monaural amplifier, such os a PA
amplifier.
When you set MONO/STfcREO to STEREO, the mixer keeps tho left and right
stereo channels separated, then sends the signals to the OUIPUT R and L
jacks. The stereo Output signals can be used by a stereo amplifier or tape
deck.
7.USING THE CROSSI-ADER
When two channels ore playing at the same time, slide CROSSFADER to.
A <A' To fade in the input source selected by ASSIGN A and fade out the
input source selected by ASSIGN fi
12