Pyranha SPRAYMASTER SM55

Questions and Answers

T
Theodore McknightAug 5, 2025
Why is the Pyranha Paint Sprayer spray not killing insects?
- M
  Michelle JohnsonAug 5, 2025
  To address the issue of spray not effectively killing insects with your Pyranha Paint Sprayer, first, ensure the pressure is between 190psi and 210psi by adjusting the pressure regulating valve clockwise. Avoid completely closing the valve. Next, confirm the clock has the correct time and adjust spray times, potentially increasing frequency and duration initially. Clean the spray tip with a damp cloth or steel wool. If pressure drops to zero, replace the check valve. Also, verify that you are using the correct concentrate refill for your system size.
V
vbestAug 10, 2025
What to do if Pyranha SPRAYMASTER SM55 Paint Sprayer motor is bogged down and overheating?
- J
  Juan ClarkAug 10, 2025
  If your Pyranha Paint Sprayer motor seems bogged down, causing the system to shut off and overheat, first, turn the Pressure Regulating Valve counterclockwise until the pressure gauge reads between 190psi and 210psi. If the issue persists, you may need to purchase a new check valve. In some cases, the motor or pump may need to be replaced.
M
Michael HansenAug 14, 2025
How to fix dripping spray tips on Pyranha SPRAYMASTER SM55?
- C
  Craig WhiteAug 15, 2025
  To resolve dripping spray tips on your Pyranha Paint Sprayer, begin by adjusting the Pressure Regulating Valve counterclockwise until the pressure gauge is between 190psi and 210psi. Ensure the spray tip is tightened securely in the nozzle barrel. Check for air bubbles in the tubing and run the system with the bleed valve open until a consistent flow of liquid is observed, then close the bleed valve. If the issue continues, consider purchasing a new check valve.
P
paulachanAug 20, 2025
What to do if Pyranha SPRAYMASTER SM55 runs but is not pumping fluid?
- M
  Mary ShafferAug 20, 2025
  If your Pyranha Paint Sprayer system runs but isn't pumping fluid, first, ensure the tank is filled with water and your preferred concentrate. Check the intake filter for clogs, removing and rinsing it clean or replacing it if necessary. If these steps don't work, you may need to prime the pump by removing the nozzle tubing from the discharge elbow and pressing the 'Extra Run' button. If fluid shoots out, reattach the tubing and open the bleed valve until liquid appears, then close it. Alternatively, remove the system from the drum, detach the intake filter, and use a low-pressure water hose on the brass fitting while pressing 'Extra Run'. If neither option works, a new pump may be needed.
R
Ryan GarzaAug 25, 2025
Why are not all nozzles spraying on my Pyranha SPRAYMASTER SM55 Paint Sprayer?
- S
  stephaniejimenezAug 26, 2025
  If your Pyranha Paint Sprayer isn't spraying from all nozzles or has very little spray, first, adjust the Pressure Regulating Valve clockwise until the pressure gauge reads between 190psi and 210psi. If that doesn't solve the problem, consider purchasing new spray tips. Also, check and clean or replace the intake filter.
S
Sarah SullivanAug 30, 2025
What to do if Pyranha Paint Sprayer does not run automatically?
- M
  Manuel JonesAug 30, 2025
  If your Pyranha Paint Sprayer system does not run automatically or when you press the extra run button, check the breaker panel and ensure the receptacle has power by plugging in another appliance. Also, ensure the tank is filled with water and concentrate, as an empty tank can cut power to the motor. Lastly, verify that the float line is not being pulled or tangled.