EasyManua.ls Logo

pyromaster UVHB20 - User Manual

pyromaster UVHB20
16 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
Vent-Free
Gas Room Heaters
INSTALLER: DO NOT DISCARD THIS MANUAL -
Leave in fireplace for homeowner.
Homeowner's Installation and
Operating Manual
PLEASE READ THIS MANUAL
BEFORE INSTALLING
AND USING APPLIANCE.
IMPORTANT: Read all instruc-
tions and warnings carefully
before starting installation. Fail-
ure to follow these instructions
may result in a possible fire haz-
ard and will void the warranty.
WARNING: If the information in
this manual is not followed ex-
actly, a fire or explosion may
result causing property damage,
personal injury or loss of life.
FOR YOUR SAFETY
Installation and service must be
performed by a qualified installer,
service agency, or the gas sup-
plier. Do not store or use gasoline
or other flammable vapors and
liquids in the vicinity of this or any
other appliance.
FOR YOUR SAFETY
If you smell gas:
1. Open windows
2. Do not touch electrical
switches.
3. Do not try to light any appli-
ance.
4. Extinguish any open flame.
5. Do not use the phone in your
building.
6. Immediately call your gas
supplier from a neighbor's
phone.
7. Follow your gas supplier's
instructions.
8. If you cannot reach your gas
supplier, call the fire depart-
ment.
This is an unvented gas-fired
heater. It uses air (oxygen) from
the room in which it is installed.
Provisions for adequate combus-
tion and ventilation air must be
provided.
UVHB20
20001540 2/04 Rev. 4
D
E
S
I
G
N
C
E
R
T
I
F
I
E
D
3501 West Howard • Skokie, IL 60076 • 847-676-3556
www.cfmharris.com

Questions and Answers

  • S
    Sarah MooreAug 10, 2025
    What to do if pilot light won't stay lit on pyromaster UVHB20 Heater?
    • M
      Melissa HernandezAug 10, 2025
      If the pilot light on your Pyromaster Heater won't stay lit and the thermopile needs a minimum of 325mV, try adjusting the pilot flame height. Also, check all wiring connections. If the problem persists, the thermopile may need to be replaced. Note that the thermocouple needs a minimum of 14mV.
  • C
    Christopher ClineAug 25, 2025
    How to fix pilot light when piezo igniter doesn't work on pyromaster UVHB20?
    • R
      Robert KnightAug 26, 2025
      If the pilot light of your Pyromaster Heater does not ignite when using the Piezo ignitor, ensure there is a 1/8" gap to the pilot hood for spark at the electrode while depressing Piezo. Also, check all wiring connections. If the issue continues, consider replacing the Piezo ignitor.

pyromaster UVHB20 Specifications

General IconGeneral
Brandpyromaster
ModelUVHB20
CategoryHeater
LanguageEnglish