V2 GSM Installation Manual
Pyronix Ltd Page: 10
CHAPTER 5: V2 GSM PROGRAMMING
5.1 PLAY / RECORD SYSTEM VOICE MESSAGES [100]
Voice or SMS messages can be recorded for all system messages on the V2 GSM:
Low battery message = If the GSM voltage supply equipment battery drops below 11.5V
a low battery message will be sent to the programmed telephone number (if enabled)
Battery restore message = Once the battery has been reconnected/recharged a
message will be sent to the programmed telephone number (if enabled)
Test Message = A test call can be sent over a programmed period (if enabled) (function
175 page 17).
Jamming Message = A jamming call can be sent if a jamming signal has been received.
Jamming Restore Message = A jamming restore call can be sent if a jamming signal
restore has been received.
A recording may be up to 12 seconds long.
Default = All system messages are disabled.
Press the [ or ] keys to scroll to
‘PLAY/REC SYSTEM VOICE
MESSAGES’ or enter ‘100’.
Press B to enter the function to
enter the sub-menus. Press the t
key to enter a sub-menu.
5.1.1 Play / Record Low Battery Message [101]
Press the t key to play/record low
battery messages
See Section 5.1.4 On how to
play/record/delete messages.
5.1.2 Play / Record Battery Restore Message [102]
Press the t key to play/record
battery restore messages
See Section 5.1.4 On how to
play/record/delete messages.
5.1.3 Play / Record Test Message [103]
Press the t key to play/record test
messages
See Section 5.1.4 On how to
play/record/delete messages.
To Next Page
Loading...