Pyronix V2 GSM - Example V2 GSM Setup Guide; Input Diagnostics and Voltage Check Example; Example Input Allocation and Phone Number Programming; Example Voice Messaging Setup

V2 GSM Installation Manual
Pyronix Ltd Page: 45
CHAPTER 9: SETTING UP THE V2 GSM (EXAMPLE)
If possible it would be ideal to have the V2 already installed before programming to check
the quiescent state of the Inputs to be used.
The V2 when powered up for the first time should already be in the Engineers Menu.
Below is an example using one Input to dial three telephone numbers:
Enter 551 for Diagnostics for input 1 and then press the t key.
This will show the status and the voltage of input 1 and should be showing CL- H /REST/
11.0V this is just a typical example if using the Bell output trigger on an alarm panel.
When the Input on the V2 is then triggered the readings should change:
Example: CL – L /ALARM/ < .5V
Codes 401 – 406 program the input status controls whether the inputs are in
the REST or ALARM state.
CL-H CL-L OPEN indicates what option in Program Input Status should be selected for
the Input to show REST state when the Input is in its quiescent state.
CL-H = Normally High Voltage Range: 10-14V
CL-L = Normally Low Voltage Range: 0–3V
OPEN = Normally Open Voltage Range: 5–7V
At default the V2 Program Input Status 401 – 404 is set to Normally High.
The default input status for 405 – 406 are set to Normally Open.
To exit the diagnostic readings press the x key twice, this should return you to the main
menu.
(If you need to change the input status do so then return back to the diagnostics readings
to check the input is now working as expected).
Enter code 201 Enable inputs for Tel #1 then press the t key.
Press the 1 key the number 1 should appear then press the t key.
Press the B arrow to show Enable inputs for Tel #2 then press the t key.
Press the 1 key again 1 should appear then press the t key.
Press the B arrow to show Enable inputs for Tel #3 then press the t key.
Press the 1 key again 1 should appear then press the t key.
Press the x key you should return to the Main Menu.
Enter code 608 SIM telephone number then press the t key.
Enter the SIM Card Telephone Number then press the t key.
Enter code 999 Quit/Exit Programming then press the t key.
Enter Code 1234 to enter the User Menu.
If you are using voice messaging Enter code 801 play/rec msg for input: 1 then
press the t key.
Press the 4
key and wait till the countdown ends then record the message press the
x key when finished recording.