© 2005 Directed Electronics—all rights reserved
1133
((++)) PPoossiittiivvee LLiigghhtt FFllaasshh OOuuttppuutt
((--)) LLiigghhtt FFllaasshh OOuuttppuutt
NNOOTTEE::
For parking light circuits that draw 10 amps or more, the internal jumper must be switched
to a (-) light flash output. (See the Internal Programming Jumper section of this guide.)
PP//NN 88661177
or a standard automotive SPDT relay must be used on the H1/2 light flash output harness wire.
This input comes from the factory set to 2 activation pulses. This means that it is necessary to have 2 consecu-
tive ground pulses on the white/blue wire for the remote start to activate or to deactivate. The same holds true
for the remote control activation when set to a two pulse setting it is necessary to press the button twice
for the remote start to activate or deactivate.
NNOOTTEE::
When the activation pulse count can be programmed to 1, 2, or 3 pulses when changed
it will affect both activation inputs; the White/Blue wire and the remote control activation.
HH11//33 WWHHIITTEE//BBLLUUEE ((--)) rreemmoottee ssttaarrtt aaccttiivvaattiioonn iinnppuutt
To Next Page
Loading...
