© 2005 Directed Electronics—all rights reserved
1177
Connect this wire to the second ignition or accessory wire in the vehicle (selectable menu feature 2-9).
If additional current capacity is needed cut this wire, add a fuse adequate for the circuit to be supplied, and
connect to an additional 12V source.
aauuxxiilliiaarryy hhaarrnneessss ((HH22)) wwiirree ccoonnnneeccttiioonn gguuiiddee
This wire sends a negative pulse every time the remote start is activated or the doors are unlocked. This can be
used to pulse the disarm wire of the vehicle's factory anti-theft device. Use a relay to send a (-) or (+) pulse to
the disarm wire as shown in the following diagrams.
RReellaayy ffoorr NNeeggaattiivvee ((--)) DDiissaarrmm WWiirree RReellaayy ffoorr PPoossiittiivvee ((++)) DDiissaarrmm WWiirree
Connect this wire to the wire in the vehicle that sends the signal to turn on the WAIT-TO-START bulb in the dash-
board. In most diesels the wire is negative (ground turns on the bulb) and the GRAY/BLACK can be directly
connected to the wire in the vehicle. If the vehicle uses a positive wire (12V to turn on the bulb) a relay must
be used to change the polarity. (See
Finding the Wait-To-Start Bulb Wire For Diesels
section of this guide.) Here
are some common colors of this wire:
■ Chevrolet and GMC trucks: Light Blue or Dark Blue
■ Ford Trucks: Black/Pink
■ Dodge Ram Trucks: Orange/Black or Black/Orange
HH22//22 GGRRAAYY//BBLLAACCKK ((--)) ddiieesseell wwaaiitt--ttoo--ssttaarrtt bbuullbb iinnppuutt
HH22//11 GGRREEEENN//BBLLAACCKK ((--)) ffaaccttoorryy aallaarrmm ddiissaarrmm
RREEDD//WWHHIITTEE 1122 VV iinnppuutt
PPIINNKK//WWHHIITTEE ((++)) oouuttppuutt ttoo sseeccoonndd iiggnniittiioonn//aacccceessssoorryy cciirrccuuiitt
To Next Page
Loading...
