1188
© 2005 Directed Electronics—all rights reserved
NNOOTTEE!!
A 1-amp diode must be installed in line on the factory wire between the wait-to-start
indicator and the ECM. (See the following diagram for details.)
This wire sends a negative pulse every time the remote start shuts down or the doors are locked. This can be used
to pulse the arm wire of the vehicle's factory anti-theft device. Use a relay to send a (-) or (+) pulse to the arm wire.
This wire provides 200 mA programmable output. (See
Feature Descriptions
section of this guide.)
HH22//44 VVIIOOLLEETT//BBLLAACCKK ((--)) cchhaannnneell 44 oouuttppuutt
HH22//33 GGRREEEENN//WWHHIITTEE ffaaccttoorryy rreeaarrmm oouuttppuutt
To Next Page
Loading...
