© 2005 Directed Electronics—all rights reserved
3311
One, if you just programmed Feature 1-2 and you next want to program Feature 1-3 to off, release the
Valet/Program switch. Press and release it once to advance from Feature 1-2 to Feature 1-3. Then press it once
more and
HHOOLLDD
it. The LED will flash in groups of 3 and the horn will honk 3 times (if connected) to confirm that
you have accessed Feature 1-3.
The learn routine will be exited if:
■ The ignition is turned on.
■ The Valet/Program switch is pressed too many times.
■ More than 15 seconds elapses between programming steps.
One long horn honk (if connected) indicates that the Learn Routine has been exited.
To Next Page
Loading...
