Python 571XP - Page 39

© 2005 Directed Electronics—all rights reserved
3399
rraappiidd rreessuummee llooggiicc
The Rapid Resume Logic feature ensures that when the security system is powered back up after power has been
disconnected, the system will resume the same state it was in before power was lost. For example, if power is
disconnected during a full trigger sequence, the system will still be in the full trigger sequence when power is
reconnected to the unit. If power is disconnected while the unit is disarmed, it will still be disarmed when power
is restored.
rreeaarr ddeeffooggggeerr ccoonnttrrooll
The rear defogger output can be remotely turned on/off any time using the remote control. The default setting
is
OONN
.
To turn the rear defogger output OFF:
1. Press & release the and and buttons of the remote control.
2. The parking lights will flash 2-times.
3. The rear defogger output will no longer activate when the vehicle is remote started.
NNOOTTEE::
If the remote start is On the lights will turn off then flash 2-times before returning to
their normal output and the defogger output, if active, will cease.
To turn the rear defogger output ON:
1. Press & release the and and buttons of the remote control.
2. The parking lights will flash 3-times.
3. The rear defogger output will once again activate when the vehicle is remote started.
NNOOTTEE::
If the remote start is On the lights will turn off then flash 3-times before returning to
their normal output and the defogger output will activate as programmed.