EasyManua.ls Logo

PZRacing Start Plus ST400-P - User Manual

PZRacing Start Plus ST400-P
12 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
Start Plus ST400-P
User Manual - v1.0 – 29/06/2022
Index
1 – Introduction......................................................................................................................................................................................................................... 1
1.1 – GPS Technology.......................................................................................................................................................................................................... 1
1.2 – Package content......................................................................................................................................................................................................... 2
1.3 – Technical features...................................................................................................................................................................................................... 2
1.4 – Important information for correct usage................................................................................................................................................................... 2
2 – Dashboard components...................................................................................................................................................................................................... 2
3 – Installation.......................................................................................................................................................................................................................... 3
3.1 – Positioning................................................................................................................................................................................................................. 3
3.2 – Power......................................................................................................................................................................................................................... 3
3.3 – Internal memory....................................................................................................................................................................................................... 4
3.4 – RPM cable installation.............................................................................................................................................................................................. 4
Important information regarding installation - READ CAREFULLY................................................................................................................................ 4
4 – Usage.................................................................................................................................................................................................................................. 4
4.1 – Switch on/off............................................................................................................................................................................................................. 4
4.2 – Registering sessions.................................................................................................................................................................................................. 4
4.3 – GPS signal................................................................................................................................................................................................................. 4
4.4 – Buttons...................................................................................................................................................................................................................... 5
5 – Configuration...................................................................................................................................................................................................................... 5
5.1 – Backlight.................................................................................................................................................................................................................... 5
5.2 – Alarms....................................................................................................................................................................................................................... 5
5.3 – Led Bar...................................................................................................................................................................................................................... 5
5.4 – User settings.............................................................................................................................................................................................................. 5
5.5 – Dash settings............................................................................................................................................................................................................. 6
6 – Screens................................................................................................................................................................................................................................ 7
6.1 – Screens activation and deactivation........................................................................................................................................................................... 7
6.2 – Configurable screen setting....................................................................................................................................................................................... 7
7 – Calibration.......................................................................................................................................................................................................................... 8
7.1 – Suspensions (only with optional box expander).............................................................................................................................................................. 8
7.2 – Gear indication (only with optional box exapnder)......................................................................................................................................................... 8
7.3 – Steering wheel angle / lean angle.................................................................................................................................................................................... 8
8 – How to use and choose the finish line/circuit.................................................................................................................................................................... 8
8.1 – Closed circuit............................................................................................................................................................................................................. 8
8.2 – Point to point............................................................................................................................................................................................................ 9
8.3 – Acceleration............................................................................................................................................................................................................... 9
8.4 – Dyno Bench............................................................................................................................................................................................................... 9
9 – Storage of a new finish line/circuit..................................................................................................................................................................................... 9
9.1 – Changing the name of the track................................................................................................................................................................................. 9
9.2 – Setting of finish line coordinates............................................................................................................................................................................... 9
10 – Session analysis............................................................................................................................................................................................................... 10
10.1 – Viewing all sessions................................................................................................................................................................................................ 10
10.2 – Deleting a session.................................................................................................................................................................................................. 10
10.3 – Session display by track......................................................................................................................................................................................... 10
10.3 – Session display by date.......................................................................................................................................................................................... 10
11 – Viewing values in real time.............................................................................................................................................................................................. 10
12 – PC connection.................................................................................................................................................................................................................. 11
12.1 – USB data download................................................................................................................................................................................................. 11
12.2 – Wi-Fi....................................................................................................................................................................................................................... 11
13 – Accelerometer.................................................................................................................................................................................................................. 11
14 – Self-diagnosis................................................................................................................................................................................................................... 11
15 – Firmware installed and date of first use........................................................................................................................................................................... 11
16 – Replace the startup image................................................................................................................................................................................................ 11
17 – Reset procedure............................................................................................................................................................................................................... 12
1 – Introduction
Thank you for choosing a PZRacing product. Start Plus is a state-of-the-art GPS dashboard. There are many advantages to this technology: you will no
longer need to place a bulky infra-red transmitter at the side of the track, you can even view split times on the display and thanks to specially designed
software, you can view all the trajectories covered on a given track.
Please note: PZRacing products are water resistant but not waterproof; do not wash the product with pressurised water and keep
the lateral tab closed at all times; failure to do so could cause permanent damage to the product.
1.1 – GPS Technology
The Global Positioning System (also known as GPS) is a satellite positioning and navigation system which, thanks to a network of artificial satellites in
orbit, sends information about geographic coordinates and the time to a GPS receiver, in any weather conditions and on any place on Earth. Its
functioning principle is based on a spherical positioning method which measures the time taken by a radio signal to cover the distance from a satellite to
a receiver. One of the main features of GPS receivers is the update frequency expressed in Hertz (Hz); this measurement unit indicates how many times
per second the satellite receiver is capable of updating its position. Start has a state-of-the-art GPS receiver with an updating frequency of 50Hz (50
times per second), which translates into higher precision in calculating the time and visualising trajectories.
PZRacing Via de Gasperi 5 – 61032 Fano (PU) Italy - Tel: +39 0721 820434 – Email: tech@pzracing.it
Question and Answer IconNeed help?

Do you have a question about the PZRacing Start Plus ST400-P and is the answer not in the manual?

Overview

The PZRacing Start Plus ST400-P is a state-of-the-art GPS dashboard designed for motorsports, offering a comprehensive suite of features for performance analysis and real-time data display. This device is specifically engineered for use in open spaces, providing accurate and detailed information to enhance the driving experience.

Function Description:

The Start Plus ST400-P integrates a 50Hz GPS receiver, enabling precise tracking and timing with 1/100s precision. It manages up to three split times and visualizes GPS speed, ideal time, and two predicted time visualizations. The device stores values per lap, absolute best times, and memorizes trajectories, allowing for in-depth analysis of performance. It features two configurable alarms (Best & Split Time/Shiftlight/Temp warning) and a configurable LED bar that can operate in RPM or chrono mode.

The dashboard includes two engine meters and two odometers, providing essential engine and distance data. It can retrieve data from up to nine analogue channels and three digital channels, with a 50Hz sampling rate for connected channels. An optional inserted gear indicator is available. The device boasts automatic circuit recognition and a global circuits database, simplifying setup for various tracks. Users can also set up new circuits via PC. An integrated lithium battery powers the device, with an option for external battery connection. It features automatic shutdown, backlight, an anti-impact container, and is water-resistant.

Important Technical Specifications:

  • GPS Receiver: Integrated 50Hz GPS receiver
  • Precision: 1/100s
  • Split Times: Management of up to 3 split times
  • Display Screens: 3 fixed + 2 configurable
  • Alarms: 2 configurable (Best & Split Time/Shiftlight/Temp warning)
  • LED Bar: Configurable (RPM or chrono mode)
  • Meters: 2 engine meters, 2 odometers
  • Channels: Retrieval of up to 9 analogue channels and 3 digital channels
  • Sampling Rate: 50Hz for connected channels
  • Battery: Integrated lithium battery, optional external connection
  • Durability: Anti-impact container, water-resistant
  • Dimensions: 135x94x33mm
  • Package Contents: Start Plus unit, USB cable type C, 3 flanged screws for plastic adaptor, 2 plastic adaptors for bolt, M8x3cm bolt for fixing onto the bracket, self-locking M8 nut, metal washers, 2 anti-vibration PVC plane washers, RPM cable 2mt.

Usage Features:

The device is designed for exclusive use in open spaces. Before use, it requires satellite reception to be completed, indicated by the GPS icon on a black background in the top left corner. After long periods of inactivity, satellite detection may take up to 4-5 minutes, but under normal track conditions, it typically takes only a few seconds.

Installation:

For motorcycles, the Start Plus ST400-P is installed by positioning the dashboard on the handlebar to ensure good visibility and a 45° angle relative to the ground for optimal GPS reception. The GPS receiver performs best when unobstructed by metal or carbon fiber components. For scooters and go-karts, it is recommended to use resistive spark plugs and shielded caps with 5K resistance to avoid interference. If non-resistive spark plugs are used, a resistive spark plug wire (e.g., NGK BR7ES) is recommended.

Power Management:

The device operates on an integrated lithium battery. To charge, connect the USB cable to a power source or USB port. A "Charging complete" message will appear on the display when fully charged. For extended use, an optional external battery connection is available.

Dashboard Components:

The dashboard features several buttons and indicators:

  • ALLARME 1/ALARM 1 & ALLARME 2/ALARM 2: Alarm indicators.
  • BARRA LED/LED BAR: Configurable LED bar.
  • PULSANTE 1/BUTTON 1, PULSANTE 2/BUTTON 2, PULSANTE 3/BUTTON 3, PULSANTE 4/BUTTON 4: Control buttons for navigation and selection.
  • DISPLAY/DISPLAY: Main screen for data visualization.
  • ANTENNA GPS/GPS ANTENNA: GPS receiver.
  • ATTACCO STAFFA/VOLANTE/STEERING/PLATE FIXING: Mounting point for bracket.
  • CONNETTORE ESPANSIONE/EXPANSION CONNECTOR (EXT): Port for expansion modules.
  • FISSAGGIO CAVO RPM/RPM CABLE FIXING: Connection for RPM cable.
  • CONNETTORE SENSORI/SENSORS CONNECTOR (SENS): Port for sensor connections.

Screen Management:

The Start Plus offers five different screens, three fixed and two fully configurable. Screens can be changed by briefly pressing button 1. Fixed screens can be activated or deactivated via the MENU (button 3), navigating to the DISPLAY icon with buttons 1-2, confirming with button 3, and then selecting the screen with buttons 1-3 and activating/deactivating with button 2. Configurable screens are modified by selecting MODIFY on the desired screen. The display is divided into nine quadrants (3x3), where different parameters can be assigned. Some fields, like the RPM graphic bar, occupy multiple quadrants. Parameters are selected using buttons 1 and 2, confirmed with button 3, and placed in the desired quadrant.

Calibration:

  • Sensors: Linear potentiometers (POTENTIOMETER 150mm and POTENTIOMETER 100mm) can be connected to the analogue inputs. Calibration involves entering the MENU, selecting CALIBRATION and then SUSPENSION, and adjusting input values to their maximum extension and press CALIB.
  • Gear Indication: For vehicles without an optional box expander, gear indication is set by starting with the vehicle in neutral, pressing CALIB, engaging first gear, and reaching a constant engine speed (approx. 5000 RPMs). The process is repeated for all gears. For vehicles with a box expander, select RPM/SPEED1 or BOX-MINI and follow the same procedure.
  • Analogue Input: To set up analogue inputs, connect the sensor, press CALIB, and follow the on-screen instructions to confirm the input.
  • Steering Wheel Angle/Lean Angle: Calibration involves setting the linear potentiometers directly from the instrument.

Finish Line/Circuit Management:

The device allows users to choose how to define the finish line. In the MENU, select TRACK and then TRACK ICON.

  • CLOSED CIRCUIT: For race tracks, kartdromes, etc.
  • POINT TO POINT: For rallies or road races.
  • ACCELERATION: For acceleration races.
  • DYNO BENCH: For dyno bench use. Users can select the finish line and circuit from the TRACK menu, accessing the Menu and clicking on the TRACK icon.

Closed Circuit Setup:

A new circuit is created by selecting NEW (button 2) in the TRACK menu, entering a name, and confirming with button 3. The name can be up to eight characters. The finish line coordinates are stored by pressing the S1 button for split time 1 or FINISH for the finish line. Up to three split times can be saved.

Session Analysis:

Stored sessions can be viewed by pressing the LAPS button (button 2) from the main screen.

  • Viewing All Sessions: Select the ALL icon in the LAPS menu to see all stored sessions in chronological order. Press CONFIRM to view all recorded times. For each lap, the number, total time, and split times are displayed.
  • Viewing Single Lap Details: Selecting a single lap allows viewing detailed parameters (GPS speed, RPM, TEMP, Thermo K), their maximum and minimum values, and a real-time display of values on a graph.
  • Deleting a Session: In the session selection screen, display the session to be deleted, hold down the CONFIRM button until "Delete parameter: Are you sure?" appears, then press CONFIRM to delete.
  • Session Display by Track: Select the TRACK icon in the LAPS menu to view sessions filtered by track.
  • Session Display by Date: Select the DATE icon in the LAPS menu to view sessions filtered by date, displaying the best three times of the day.

Real-Time Values:

The real-time values screen displays all measurements retrieved by the GPS and analogue/digital measurements from the Box Expander. Access this screen via the MENU, selecting the INFO icon, then VALUE. Analogue channels (ANALOG X) and SPEED 1/2 will appear with default names unless changed. Names can be changed in the CONFIG.CFG file via RacePro software.

Maintenance Features:

  • USB Data Download: Stored data (laps, sessions) can be downloaded to a PC via USB cable. The data is saved in the SESSION folder.
  • Wi-Fi Module: The Start Plus is equipped with an integrated Wi-Fi module for data download and settings. The Wi-Fi module can be turned off/on via the menu. The device creates a network (PZRacing ST400P-USER 1, password 12345678) for connection.
  • Accelerometer: An internal accelerometer measures acceleration and inclination. Calibration ensures accurate readings.
  • Self-Diagnosis: The Start Plus has a self-diagnosis function that verifies all features. It displays INFO messages for normal operation and ERROR messages for malfunctions.
  • Firmware Update: Firmware updates are installed by connecting the device to a PC and using the RacePro software. The update process displays the current and new firmware versions.
  • Replace Startup Image: The startup image can be customized by inserting an image in the IMAGE folder. Supported formats are bitmap (.bmp) with dimensions 240x320px and 256 colors.
  • Reset Procedure: In case of device freeze, simultaneously press buttons 3 and 4 for approximately 15 seconds until the product turns off. This procedure should only be used in case of need.

PZRacing Start Plus ST400-P Specifications

General IconGeneral
BrandPZRacing
ModelStart Plus ST400-P
CategoryMeasuring Instruments
LanguageEnglish