To Next PageTo Next Page
Need help?Do you have a question about the Q-Connect Q12CC and is the answer not in the manual?
General| Shred Size | 4 x 35 mm |
|---|---|
| Security Level | P-4 |
| Shred Capacity | 12 sheets |
| Bin Capacity | 23 liters |
| Shred Type | Cross Cut |
| Power | 220-240V |
Remove packaging, shredder head, and castors before assembly.
Insert castors into the lower casing slots until they click firmly into place.
Securely place the shredder head onto the waste bin, ensuring it clips firmly.
Check 'Door Open' indicator if the head is not seated correctly; it prevents operation.
Inspect the shredder, cable, and plug for any damage or defects before operation.
Position the shredder away from heat sources and water to prevent damage.
Always set the switch to 'off' before connecting the shredder to the mains power.
Keep loose clothing, jewelry, and long hair away from the shredder to avoid entanglement.
Ensure children and pets are kept away from the operating shredder for their safety.
Unplug the shredder from the mains when not in use or during maintenance.
Never insert fingers or any objects into the shredder's feed slot.
Do not dismantle the shredder; seek authorized service for repairs.
Do not shred materials contaminated with flammable chemicals or use flammable aerosols nearby.
Set the switch to 'Auto' to place the shredder in standby mode.
Set the ShredSafe cover to position 2 for normal paper and credit card shredding.
The shredder starts automatically when paper is fed straight into the entry slot.
Do not exceed 12 sheets of 75gsm paper; heavier paper reduces capacity.
Do not operate continuously for more than 5 minutes to prevent overheating.
Use the reverse function to clear jams caused by overfeeding or crooked paper.
Use ShredSafe open position for credit cards and the CD slot for CDs (one at a time).
Details positions: 1 Closed (CD only), 2 Open (Normal), 3 Fully Open (Safety Off).
Cover pushing open in position 2 cuts power to prevent injury if fingers are inserted.
Illuminates when power is on and ShredSafe flap is in positions 1 or 2.
Illuminates when too much paper is fed into the feed slot.
Illuminates when the waste bin door is open.
Illuminates when the operational temperature is exceeded; requires cooling.
Troubleshooting steps for non-operation, including checking power, auto mode, ShredSafe, door, and overheating.
Addresses continuous operation due to a full bin or blocked auto sensor.
Instructions for clearing jams, including using reverse and checking capacity.
Empty the waste basket frequently to ensure optimal performance.
Reversing the shredder helps clear paper dust, particles, and minor jams.
Oiling is not necessary but may extend life; use non-aerosol vegetable oil.
Avoid using implements to clear jams; follow procedures to prevent damage.
