Need help?Do you have a question about the Q-SUN Xe-1 and is the answer not in the manual?
General| Brand | Q-SUN |
|---|---|
| Model | Xe-1 |
| Category | Test Equipment |
| Language | English |
Details operating conditions, installation category, pollution control, sound pressure, altitude, and supply connection requirements.
Illustrates and explains safety symbols including electrical shock, hot surfaces, attention, and finger/hand crushing hazards.
General statement on Q-Lab's responsibility and user's duty for safe operation and practices.
Identifies heat, electrical shock, and ultraviolet hazards with associated warning labels and interlock mechanisms.
Explains UV light hazards from lamps, importance of interlocks, and absence of UV hazard with closed doors.
Introduces the Quick Setup Guide's purpose and the models covered in the document.
Specifies recommended ambient temperature, humidity, and physical room conditions for optimal tester operation.
Lists environments to avoid, such as salt fog, airborne dust, uncontrolled temperature/humidity, and direct air sources.
Provides general instructions and safety precautions for uncrating the tester.
Details the uncrating procedures for Q-SUN Xe-1 models that do not include a chiller.
Details the uncrating procedures for Q-SUN Xe-1 models that include a chiller.
Outlines the physical dimensions and necessary clearances for installing the Q-SUN Xe-1 testers.
Covers voltage, current, frequency, installation category, and power connection requirements for the testers.
Details purified water needs, system requirements, and connection configurations for specific Xe-1 models.
Explains how Xe-1 models release warm air and their heat load dissipation by model type.
Introduces the start-up procedures and refers to technical manuals for detailed operation.
Describes the power switch, touch screens, Menu Screen, and Status Screen for Xe-1 "E" models.
Details the power switch, keypad, status/message display, and test monitor display for the Xe-1-B model.
Provides contact details for Q-Lab Repair and Tester Support, including hours and website.
To Next Page