To help keep the Finger Slam Guard handy
and out of reach for children when not in
use we have included an Adhesive Storage
Post. Decide the best location for storing
the Finger Slam Guard, we suggest the
door frame or the back of the door.
To mount the Storage Post, remove adhesive protective
liner then press firmly into place for 30 seconds.
Use a rounded knife and carefully pry behind a corner of
the Storage Post until the tape tears.
For remaining tape residue, use a finger to simply rub it
away. If any residue still remains, use a cleaner that will not
damage the surface you are removing the residue from.
There is no way to test all possible surfaces SecureHold
Adhesive will be applied to; please use caution when
removing to avoid damaging the surface. SecureHold
adhesive may cause damage to some surfaces.
Storage when not in use
To Permanently Remove Storage Post
To Previous Page