To Next PageTo Next Page
Need help?Do you have a question about the Qdos Auto-Close SafeGate and is the answer not in the manual?
Details minimum and maximum opening sizes with extension configurations for the gate.
Critical safety precautions and warnings for secure installation and proper use of the gate.
Information on safety standards the gate meets or exceeds.
Contact information and resources for installation help and FAQs.
Instructions for regular checks, tightening hardware, and cleaning the gate.
Information on the product's warranty period and coverage for defects.
Guidance on suitable and unsafe locations for gate installation, including stairs.
Table detailing required extensions based on opening width and placement.
Explanation of why wall cups are essential for gate stability and safety.
Guidance on using adhesive-only versus adhesive with screws for wall cups.
Visual identification of top and bottom spindle housings and spindles.
Visual identification of the gate itself, wall cups, screws, and installation wrench.
Guidelines for selecting strong, rigid surfaces and avoiding trip hazards.
Information on optional accessories for specific mounting situations like banisters.
Determine required extensions by measuring the opening width.
Ensure handwheels or nuts are screwed out towards the spindle heads.
Correctly insert bottom and top spindle housings into the gate frame.
Slide spindles into housings and attach extensions if needed.
Center the gate, ensure even gaps, and use the level for vertical alignment.
Push adhesive wall cups onto the spindle heads, using specified types.
Extend spindles to secure wall cups, then temporarily remove the gate.
Reposition gate and begin tightening top spindle hand wheels.
Tighten bottom spindles with wrench until indicator shows secure installation.
Adjust hand wheels for tension, cut cable tie, set 1/8-inch gap.
Verify gate is locked using the At-A-Glance Lock Indicator (Green=locked).
Install One-Way Stop for one-directional opening.
Confirm auto-close function and fine-tune gap for proper operation.
Guide on inserting extensions into spindle housings for wider openings.
Guidance on how to distribute multiple extensions on the gate.
How to open, close, and utilize the 90° stay-open feature.
Instructions for safely removing wall cups and cleaning residue.
General| Brand | Qdos |
|---|---|
| Model | Auto-Close SafeGate |
| Category | Safety Equipment |
| Language | English |
