To Next Page

To Previous Page

MAINTENANCE AND TROUBLESHOOTING

CAUTION: Be sure to switch power OFF and disconnect the plug during maintenance

and inspection.

1. Use a mixing paddle appropriate for the material you are mixing.

2. This power mixer normally requires little maintenance. It is suggested that

the ventilation space between the gear box and the motor be cleared of

debris after each use.

3.Afterapproximately100hoursofuse,checkthemotorbrushesandreplace,

if necessary.

4. Store mixer in a dry place that will not freeze.

Motor Unit:

 PowerInput: 1300Watts

 Voltage: 120V-60HZ

 NoLoadSpeed: Low:180-460RPM,High:300-700RPM

Certification: ETL

 MixingPaddle: 127mm(5”)

 Weight: 13lbs.,9oz

Double Insulated

SPECIFICATIONS

CUSTOMER AND TECHNICAL SERVICE

For customer and technical service please go to www.qep.com

orcalltollfree1-866-435-8665.

e. Run the mixer at low speed using the variable speed dial until the dry

material and water are evenly distributed. Do not run the mixer at high

speed if it appears to be slowed down or labored. If the mixer begins to heat

up, allow it to cool, then run at a lower speed.

f. When finished mixing, remove the mixing paddle from the mixer. Wipe any

water, mud or debris from the mixer with a clean, dry cloth. Wash the

mixing paddle with clean water. Do not allow grout, mortar or paint to dry

on the mixing paddle.

OPERATING INSTRUCTIONS - CONTINUED

-7-

QEP 21665Q User Manual

Questions and Answers: