Wait for the LED on the receiver to light off and enter the setting state.
Step 2) Press the button on the remote control (such as A) once. The LED on the receiver will
flash and then turn off.
Step 3) At this time, press another button (such as B) of the same remote control, the indicator
flashes and then lights up. The Toggle Mode is set successfully.
Set Latching Mode:
Step 1) Press the receiver's learning button 3 times.
Wait for the LED on the receiver to light off and enter the setting state.
Step 2) Press the button on the remote control (such as A) once. The LED on the receiver will
flash and then turn off.
Step 3) At this time, press another button (such as B) of the same remote control, the indicator
flashes and then lights up. The Latching Mode is set successfully.
TECHNICAL DATE
Input Power KR2402A:DC 6-30V
RF Frequency 433.92MHZ or 315MHZ
Standby Current 8.5mA
Load power 1100W
Receiver sensitivity -108dBM
Operation mode Momentary Mode,Toggle Mode,Latching mode
Match Way Learning button
Support remote type
Learning code （1527）
Output NO , NC , COM
To Next Page
Loading...