1111
EN
Warning! The appliance must be separated by a
distance of at least 50 cm from heat sources (such as
stoves, ovens, radiators, etc.) and at least 5 cm from
electric ovens.
1. Place the refrigerator in a well ventilated room on a dry, stable and level surface, away from
direct sunlight and other heat sources.
2. Ensure sufcient air circulation at the rear of the appliance. Do not place the appliance against
a wall to avoid noise caused by vibration. Make sure that the air can still circulate freely
around the appliance. Insufcient ventilation would result in malfunction and increased energy
consumption. Leave a space of at least 10 cm between the refrigerator and the wall, and at
least 30 cm between the top of the refrigerator and the ceiling.
3. Leave enough space to access and open the door easily: ≥ 990 x 1025 mm (g. ). If
necessary, change the direction of the door opening ( REVERSING THE DIRECTION OF
THE DOOR OPENING).
4. If the refrigerator is placed on an uneven surface, level the appliance using the adjustable feet
(g. ). This will ensure proper operation without vibration.
6. OPERATION
6.1. Commissioning the appliance
1. After transport, unpacking and installation and before the rst use, let the appliance rest for
2 hours in vertical position.
2. Clean the appliance and its components (7. CLEANING AND MAINTENANCE).
3. Connect the power plug with a wall outlet.
4. Set the temperature to a high level using the SET button (TEMPERATURE CONTROL
(REFRIGERATOR)).
5. Let the refrigerator run for 24 hours before inserting fresh or frozen foods.
6.2. Temperature control (refrigerator)
Note: The temperature inside the appliance is the result of several factors, such as the ambient
temperature, the quantity of food stored, the frequency of opening of the door, etc. Adjust the setting
accordingly using the SET button.
1. Turn the SET button to the desired position. Position 2 is for the coldest temperature, position 8
is the least cold. To stop the refrigerator completely, disconnect it from the all outlet.
2. Fast cool: Press the SET button several times until “SUPER“ is shown in the display. The
appliance will now operate for 150 minutes in a rapid cooling mode. Press the SET button
again if you want to change to a different cooling setting.
6.3. Temperature control (freezer)
The temperature control inside the freezer compartment offers 3 settings:
Setting Cleaning
NORMAL
Default position.
COLD
Ambient temperature above 35 °C. This setting is most useful during the summer.
COLDER
Ambient temperature below 10 °C. This setting is most useful during the winter.
6.4. Accessories
Various glass or plastic storage shelves are included with your appliance – different models have
To Next Page
Loading...
Need help?
General
