10
5.3. POSITIONING
Install this appliance at a location where the ambient temperature corresponds to the climate
class indicated on the rating plate of appliance:
For refrigerating appliances with climate class:
■ Extended temperate: this refrigerating appliance is intended to be used at ambient
temperatures ranging from 10°C to 32°C; (SN)
■ Temperate: this refrigerating appliance is intended to be used at ambient temperatures
ranging from 16°C to 32°C; (N)
■ Subtropical: this refrigerating appliance is intended to be used at ambient temperatures
ranging from 16°C to 38°C; (ST)
■ Tropical: this refrigerating appliance is intended to be used at ambient temperatures ranging
from 16°C to 43°C; (T)
5.4. LOCATION
The appliance should be installed well away from sources of heat such as radiators, boilers, Direct
sunlight etc. Ensure that air can circulate freely around the back of the cabinet. To ensure best
performance, if the appliance is positioned below an overhanging wall unit, the minimum distance
between the top of the cabinet and the wall unit must be at least 50mm. ideally, however, the
appliance should not be positioned below overhanging wall units. Accurate leveling is ensured by
one or more adjustable feet at the base of the cabinet.
Warning! It must be possible to disconnect the appliance from the mains power
supply; the plug must therefore be easily accessible after installation.
This refrigerating appliance is not intended to be used as a built-in appliance;
5.5. ELECTRICAL CONNECTION
■ Before plugging in, ensure that the voltage and frequency shown on the rating plate
correspond to your domestic power supply. The appliance must be earthed. The power
supply cable plug is provided with a contact for this purpose. If the domestic power supply
socket is not earthed, connect the appliance to a separate earth in compliance with current
regulations, consulting a qualied electrician.
■ The manufacturer declines all responsibility if the above safety precautions are not
observed.
■ This appliance complies with the E.E.C. Directives.
6. DAILY USE
6.1. FIRST USE
Cleaning the interior
Before using the appliance for the rst time, wash the interior and all internal accessories with
lukewarm water and some neutral soap so as to remove the typical smell of a brand new
product, then dry thoroughly.
Important! Do not use detergents or abrasive powders, as these will damage the nish.
6.2. TEMPERATURE SETTING
■ Plug on your appliance. The internal temperature is controlled by a
thermostat. There are 3 settings. MIN, NORMAL and MAX. MIN is
warmest and MAX is coldest.
■ The appliance may not operate at the correct temperature if it is in
a particularly condition hot or if you open the door often.
To Next Page
Loading...
