Qilive Q.6708 - Installation; Service and Maintenance; Energy Saving; Environment Protection

6
EN
1
If there is a light in the compartment.
2
If there is a freezer compartment.
Installation
Important! For electrical connection carefully follow the instructions given in specic paragraphs.
■ Unpack the appliance and check if there are damages on it. Do not connect the appliance if
it is damaged. Report possible damages immediately to the place you bought it. In that case
retain packing.
■ It is advisable to wait at least four hours before connecting the appliance to allow the oil to
ow back in the compressor.
■ Adequate air circulation should be around the appliance, lacking this leads to overheating.
To achieve su󰀩cient ventilation follow the instructions relevant to installation.
■ Wherever poss ble the spacers of the product should be against a wall to avoid touching or
catching warm parts (compressor, con-denser) to prevent poss ble burn.
■ The appliance must not be located close to radiators or cookers.
■ Make sure that the mains plug is accessible after the installation of the appliance
Service
■ Any electrical work required to do the servicing of the appliance should be carried out by a
qualied electrician or competent person.
■ This product must be serviced by an authorized Service Center, and only genuine spare
parts must be used.
Energy Saving
■ Don‘t put hot food in the appliance;
■ Don‘t pack food close together as this prevents air circulating;
■ Make sure food don‘t touch the back of the compartment(s);
■ If electricity goes o󰀨, don‘t open the door(s);
■ Don‘t open the door(s) frequently;
■ Don‘t keep the door(s) open for too long time;
■ Don‘t set the thermostat on exceeding cold temperatures;
■ All accessories, such as drawers, shelves
■ balconies, should be kept there for lower energy consumption.
Environment Protection
This appliance does not contain gasses which could damage the ozone layer, in either its
refrigerant circuit or insulation materials. The appliance shall not be discarded together
with the urban refuse and rubbish. The insulation foam contains ammable gases: the
appliance shall be disposed according to the appliance regulations to obtain from your
local authorities. Avoid damaging the cooling unit, especially the heat exchanger. The materials
used on this appliance marked by the symbol are recyclable.
The marking of this device (symbol of a crossed-out dustbin) complies with European
Directive 2012/19/EU relating to „used electrical and electronic equipment“. This marking
means that this equipment, at the end of its useful life, cannot be disposed of with other
household waste. The user is required to deliver it to operators who collect used electrical
and electronic equipment. Collection operators, including local collection points, shops and local
authorities, create an appropriate system for collecting equipment. Appropriate collection of used
electrical and electronic equipment helps avoid harmful impacts on human health and the
environment, resulting from the presence of hazardous components, as well as from improper
storage and treatment of this equipment.
Packaging materials
The materials with the symbol are recyclable.
Dispose the packaging in a suitable collection containers to recycle it.