To Next Page

To Previous Page

Figure 1 Figure 2

Note: Figures 1 and 2 only illustrate the space demand of the product.

3. Level ground

Place the refrigerator on the solid and at ground (oor) to keep it stable, or else, it

will give rise to vibration and noise. When the refrigerator is placed on such ooring

materials as carpet, straw mat, polyvinyl chloride, the solid backing plates should

be applied underneath the refrigerator, so as to prevent color change due to heat

dissipation.

Unobstructed ventilation shall be maintained around the appliance or in an

embedded structure.

4.2. PREPARATIONS FOR USE

1. Leveling

Make sure to level your refrigerator/freezer using the front leveling feet. If not level, the

door gasket sealing performance will be a󰀨ected, or even it may lead to the operating

failure of your refrigerator/freezer.

2. Cleaning

Conrm the accessory parts inside the refrigerator and wipe the inside with a soft cloth.

3. Standing time

After the refrigerator is properly installed and well cleaned, do not switch it on

immediately. Make sure to energize the refrigerator after more than 1 hour’s standing,

so as to ensure its normal operation.

4. Power-on

Insert the plug into the solid socket to start the compressor. After 1 hour, open

the refrigerator door, if the temperature inside the refrigerator compartment drops

obviously, it indicates the refrigeration system is working normally.

5. Storage of food

After the refrigerator runs for a period of time, the internal temperature of the

refrigerator will be automatically controlled according to the user’s temperature setting.

After the refrigerator is fully cooled, put in foods, which usually need 2~3 hours to be

fully cooled. In summer, when the temperature is high, it takes more than 4 hours for

the foods to be fully cooled (Try to open the refrigerator door as less as possible before

the internal temperature cools down).

If the refrigerator is installed in the moisture place, make sure to check

whether the ground wire and leakage circuit breaker are normal. If vibration

noises are produced due to the refrigerator contacting the wall or if the

wall gets blackened by air convection around the compressor, move the

refrigerator away from the wall. Setting up the refrigerator may cause jamming

noise or image chaos to the mobile phone, xed-line telephone, radio receiver,

television surrounding it, so try to keep the refrigerator as far away as possible

in such case.

Qilive Q.6824 User Manual

Questions and Answers: