6
EN
2. This appliance
is equipped with a single inlet valve and can be
connected to the cold water supply only.
3. Mains plug must be accessible after installation.
4. Before
washing clothes for the rst time, the product shall be
operated once throughout all the procedures without any clothes
inside.
5. Do not put any excessively heavy objects on the appliance,
like water containers or heating devices.
6. The new hose-sets supplied with the appliance
are to be used
and that old hose-sets should not be reused.
7. Max.
Inlet water pressure 1 MPa. Min. inlet water pressure
0.1MPa.
1.4. ELECTRICAL
CONNECTION
1. Make sure the supply cable is not trapped by the machine, it
can get damaged.
2. Connect
the product to a grounded outlet protected by a fuse
complying with the values in the “Technical specications” table.
The grounding installation has to be made by a qualied electrician.
Ensure that the machine is installed in accordance with the local
regulations.
3. W
ater and electrical connections must be carried out by
a qualied technician in accordance with the manufacturer‘s
instructions and local safety regulations.
W
arning!
– Don´t use multiple plugs or extension cords.
– The applian
ce must not have an external
switching device such as a timer or connected
to a circuit that is regularly switched on and o.
– Do not
pull the plug out of the mains outlet if
there is ammable gas around.
– Never pull out power plug with wet hands.
– Always pull at the plug, not at the cable.
– Always unpl
ug the appliance if it is not being
used.
1.5. W
ATER CONNECTIONS
1. Check
the connections of the water inlet tubes, the water tap
and the outlet hose for possible problems due to changes of water
pressure. If the connections loosen or leak close the water tap
To Next Page
Loading...
Need help?
General
