IV OPERATING YOUR WINE COOLER
Initial Setup
Remove exterior and interior packing materials and connect the wine cooler
to a power supply. Once it is plugged in, let it run for at least 30 minutes. Do
not change the temperature or adjust any settings at this time.
Temperature Adjustment
Your wine cooler can be set to your desired temperature. The unit’s tempera-
ture range is: 8°C to 18°C.
G
NOTE!
The winecooler does not have a compressor. This means that the wine-
cooler is very suitable for keeping the wine cool within the limitations
of the design. The winecooler will use (much) longer time to cool down
multiple bottles of warm wine. Especially in a warm environment.
When initially turned on, the LED will display the ambient temperature and
then the internal cabinet temperature. The zone temperature may have a
difference of 3ºC from setting depending on loading and ambient conditi-
ons.
1. Lower the temperature: press
2. Increase the temperature: press
Once you have set the desired temperature, the display will flash for 5
seconds and then revert to the internal cabinet temperature.
3. the interior light ON or OFF: press
Change from °C into °F
FWK 1608: press °F/°C button on display
FWK 1612: press both
and together for > 3 sec.
4
45
To Next Page
Loading...
Need help?
General