Qlink LG250 User Manual

IMPORTANT SAFETY INFORMATION
DRIVER AND PASSENGER
LG250 is designed only for one driver and one passenger. The total load must be within the limit specified
on the specification label.
ROAD CONDITION
The motorcycle is designed only for driving on paved roads.
READ THIS MANUAL CAREFULLY
Pay special attention to all the sentences or paragraphs marked with WARNING in this manual.
WARNING:
Means failure to follow the instructions will cause serious injury or death.
NOTICE:
Means that if the instructions in this manual are not observed, product damage or body injury may occur.
NOTE:
Provides you with the effective method of operation.
As the manual is considered as indispensable, it should be always kept with the driver for consultation.
USER'S MANUAL

Qlink LG250 Specifications

General

Fuel System	Carburetor
Ignition	CDI
Transmission	5-speed
Final Drive	Chain
Front Suspension	Telescopic Fork
Front Brake	Disc
Rear Brake	Drum
Width	800mm
Engine Type	4-stroke
Starting System	Electric and kick start

Summary

Important Safety Information

Driver and Passenger Safety

Motorcycle for one driver and one passenger; adhere to load limits.

Traffic Safety

Safe Driving Procedures

Pre-Ride Inspection

Inspect the motorcycle thoroughly before starting the engine.

Protective Gear Requirements

Wear helmet, boots, gloves, glasses, and noticeable clothing for safety.

Cargo Loading Guidelines

Load Capacity and Handling

Parts and Controls Identification

Operation Guide

Main Switch Operation

Ignition Button Function

Kill Switch Operation

Steering Lock Procedure

Pre-Driving Inspection

Fuel Tank Check

Procedure for checking and refilling fuel tank, including notes on fuel type.

Engine Oil Level Check

Steps to check and fill engine oil to the correct level.

Braking System Checks

Brake Fluid Level

Check brake fluid level and use specified fluid (DOT3/DOT4).

Brake Lever Free Play

Brake Lever Span Adjustment

Brake Disc Wear Inspection

Rear Brake Lock Device

Tire Maintenance and Specifications

Engine Starting Procedure

Motorcycle Driving Instructions

Basic Driving Actions

Sitting position, releasing brake, and initial throttle control.

Acceleration and Deceleration

How to increase and decrease speed using the throttle.

Braking Techniques

Proper methods for braking, including simultaneous use of front/rear brakes.

Parking and Security

Parking Procedure

Steps for safely parking the motorcycle.

Maintenance Schedule Overview

Maintenance Procedures

Air Cleaner Servicing

Steps to remove and access the air cleaner for maintenance.

Engine Oil Recommendations

Recommended Oil Grades

Lists recommended engine oil grades for different conditions.

Viscosity Selection Guide

Engine Oil and Screen Service

Engine Oil and Screen Replacement

Procedure for replacing engine oil and cleaning the oil screen.

Gearbox Oil Replacement

Ignition and Electrical Components

Spark Plug Service

Instructions for checking, cleaning, and replacing the spark plug.

Battery Replacement

Steps for removing and replacing the motorcycle battery.

Technical Specifications

Performance Metrics

Key performance data like rated power and fuel consumption.