USER'S MANUAL
6
The ignition switch has three positions
“ ” Position
The whole electrical circuit is disconnected.
“ ”Position
The ignition circuit is switched on so that the engine can be started. It is impossible
to pull out the ignition key from this position.
“ ” Position
In order to lock the handlebar, turn the bar to the left, then insert the key. Rotate it
connter - clockwise to full stop for locking the handlebar.
WARNING
If the handlebar is locked, the motorcycle is never pushed any longer; otherwise you will lose balance.
Left Handlebar Control System
Dimmer Switch
When the switch is set to “ ” (high) position, the headlamp will be switched
to h igh beam mode; the high beam indicator on the instrument panel will be lit
simultaneously. When the switch is set to “ ” (low) position, the headlamp will
be switched to low beam mode.
Turning Switch
¢Ù
¢Ú
Ignition Switch
To Next Page
Loading...