76
2. Assembly and Connections
The plug of the power supply unit serves as a disconnecting device from the mains
supply. The socket must be located close to the QLOCKTWO TOUCH and be easily
accessible.
IMPORTANT Please note the following in order to avoid material damage:
For safety instructions on positioning the clock, see Section 1.3 ‘Location’.
Fold-out page, picture
1
>
Pull the protective film off the protection strips.
>
Apply the adhesive side of the protections strips to the bottom of your QLOCKTWO TOUCH.
>
Place your QLOCKTWO TOUCH onto the magnetic stainless steel base.
Fold-out page, picture
2
>
Carefully insert the miniature USB plug into the USB connection socket on the back
of the casing.
>
Plug the USB plug into the USB power supply unit.
>
Plug the USB power supply unit into a wall socket.
WARNING
Serious to fatal injury caused by electric power
■
Do not pull electric cables; only pull out the plugs.
■
Lay cables so that they cannot be bent or get caught and are not found
in passages.
■
Check all cables for visible damage before connecting them to the
power supply. Do not connect your QLOCKTWO TOUCH to the power
supply in the event of any damage.
■
Comply with acceptable electric data for the power supply,
see Section 4 on ‘Technical Data’.
■
Do not touch cables and plugs with wet hands.
Brushed stainless steel front cover (FULL METAL):
■
Remove slight stains with the microfibre cloth (included with delivery).
■
Remove stubborn stains with a suitable stainless steel cleaner.
Coated stainless steel front cover (DEEP BLACK, GOLDEN LEGEND):
Remove dirt with a soft cloth and water containing a little dishwasher detergent.
Front cover RUST, SILVER & GOLD, VINTAGE COPER:
Carefully dust the surfaces with a soft, dry, dust-free cotton cloth or with a soft, fine
brush without applying any pressure.
1.5 Maintenance and repairs
Never attempt to repair or dismantle your QLOCKTWO TOUCH yourself.
Have a specialised dealer or the manufacturer carry out maintenance and repair
work. See the last page of these Instructions for Use for contact details.
1.6 Warranty
The warranty is valid for two years. Only use your QLOCKTWO TOUCH with original
accessories. Failure to observe the information in these Instructions for Use or modify-
ing, opening or altering your QLOCKTWO TOUCH will not be covered by our warranty.
1.7 Disposal
IMPORTANT Improper disposal pollutes the environment.
Electric appliances: Electric appliances may not be disposed of as
household waste. Observe regional disposal regulations. Dealers are
obliged to take back appliances.
Stainless steel: Stainless steel components are to be recycled as
scrap metal. Stainless steel is a valuable raw material which can be
melted and reused.
EN
To Next Page
Loading...