EasyManua.ls Logo

QLOCKTWO TOUCH - Page 5

Default Icon
8 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
98
3.2 Operation
Setting the clock:
When you connect your clock to the power supply for the first time, the time display
will blink - settings can be made immediately. Touching the [ 1 ] 1-minute step button
will set the internal counter for seconds at zero. This makes is possible to set the time
precisely to the second.
>
If the time display does not blink: Keep the [ ] button pressed for approx. 3 seconds
to go back to time setting mode.
>
Set the time of day with the [60], [ 5 ] and [ 1 ] buttons.
>
Press the [ ] button or the [ ] button.
Switching the ‘IT IS’ display on/off:
The factory setting shows the introductory words ‘IT IS’ for full hours and half hours.
>
If ‘IT IS’ is always shown:
Keep buttons [ 1 ] and [
] pressed simultaneously for approx. 3 seconds.
>
Restoring the factory setting:
Keep buttons [ 1 ] and [
] pressed simultaneously for approx. 3 seconds.
Switching the second display on/off:
The seconds appear in large numbers on the front cover.
>
Switching the second display on: Keep button [1] pressed for approx. 3 seconds.
>
Switching the second display off: Press any button.
Setting the brightness:
Automatic brightness adjustment (factory setting):
The level of brightness is adapted automatically to the surrounding light with the help
of a light sensor; it can be set in steps.
>
Press button [ ] repeatedly.
The settings will change as follows:
Strong brightness
Medium brightness
Low brightness
Non-touch mode
3. Functions and Control Elements
3.1 Time display and control elements
Time of day shown: 07:18 Control elements
ENGLISCH- dICk wEISSfILm - SEItE 2 - 15. ma Erz 2013
e ei lg eh vt e
s te wv e ln v
t Oe cn ls Oe c
n
e
k
e
O xn te hs ri e
h ta el nf fs t
f iO vu er tf w
p ra us nt ie n
O
O
e
e
s
a rc tq eu ra d
t yw fe in vt e
i at l ai ms p m
c
x
Hour display
Set with button [60]
Display in 5-minute steps
Set with button [5]
Each light point
= 1 minute later
Set with button [ 1 ]
[
] button
Brightness setting
Setting for
time of day and alarm time:
Button [ 1 ]
1-minute steps
Button [ 5 ]
5-minute steps
Button [60]
Hourly steps
[
] button
Alarm on/off
EN