1110
Showing the alarm time:
>
Keep the [ ] button pressed for approx. 3 seconds.
Setting the alarm time:
The alarm time is set in a 12-hour mode.
>
Keep the [ ] button pressed for approx. 3 seconds. The alarm time is shown.
>
Set the alarm time (like the time of day) with the [60], [ 5 ] and [ 1 ] buttons.
Switching on the alarm:
>
Press the [ ] button.
The alarm will start sounding softly and will gradually get louder.
Switching the alarm off:
>
Press the [ ] button or touch the top of the casing for approx. 2 seconds.
Snoozing:
>
Touch the top of the casing. The alarm will sound again after 5 minutes.
The function can be repeated as often as necessary.
>
End snoozing (switching the alarm off): Press the [ ] button or touch the top of the
casing for some time.
3.4 Exchanging the front cover
The matrix of letters on the front cover differs for each language. The relevant front
covers are available as accessories to be exchanged if a different language is to be
displayed.
The front cover is held in place with magnets. This is why it can easily and quickly be
exchanged if a colour or a language is to be changed.
■
Pull the front cover off the body carefully towards the front.
■
Remove the protective film from the front of the new front cover by putting it down
on a clean, level surface and slowly pulling it off, starting at a corner. Do not bend the
front cover. The need to remove protective film only applies for acrylic glass models.
■
Once this has been done, place the front cover onto the body so that it fits accurately.
Manual brightness adjustment:
Four permanently defined brightness levels are available for manual brightness
adjustment. You can choose from these by repeatedly pressing the button [
].
Switching between automatic and manual brightness adjustment:
By simultaneously pressing the [
] and [ ] buttons for three seconds, you can switch
back and forth between automatic and manual brightness adjustment. Please note
that the automatic brightness adjustment mode (factory setting) will automatically be
reactivated after a power interruption.
Night touch mode:
The time display is switched off in the night touch mode.
When the alarm is switched on only the
symbol will light up.
The night touch mode is switched on with the brightness setting.
Night touch mode functions:
>
Showing the time of day: Touch the top of the casing.
The time will appear for 3 seconds.
>
Showing the alarm time: Touch the top of the casing twice in succession.
The alarm time will appear for 3 seconds.
>
Ending the night touch mode: Switch the alarm off or press the [ ] button.
Switching the night light on/off:
The displays all light up as brightly as possible.
>
Switching the night light on: Keep button [60] pressed for approx. 2 seconds.
>
Switching the night light off: Press any button.
3.3 Alarm functions
Showing the status:
The
symbol on the front cover shows the status of the alarm.
■
Symbol lights up: alarm on
■
Symbol does not light up: alarm off
■
Symbol blinks rapidly: alarm time display
■
Symbol blinks slowly: alarm time setting
■
Symbol pulsates slowly: slumber mode
EN
To Next Page
Loading...