EasyManua.ls Logo

QLT 17C50 - Page 10

Default Icon
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Use of batteries
Keep batteries out of the reach of children
Do not allow children to change batteries without adult supervision
Do not heat batteries
Remove batteries from equipment if it will not be used for an extended period of time unless for emergencies
Always choose the correct size and type of battery most suitable for the intended use.
Information supplied with the equipment to assist in proper battery selection should
be retained for reference
Clean the battery and equipment contact points before installing the battery
If the battery compartment does not close properly, stop using the product and keep it away from children.
Ensure batteries are installed correctly with regard to polarity (+ and -).
Remove dead batteries immediately
Do not disassemble batteries
Do not throw batteries into fire except under conditions of approved and controlled Incineration
Batteries may be disposed of with household waste provided there are no local rules prohibiting this contrary rules exist.
DANGER to and from domestic and service animals!
There may be dangers to domestic and user animals from electrical appliances. Furthermore, animals can also cause damage to the appliance. Therefore,
always keep animals away from electrical appliances.
DANGER to electric shock!
Do not operate the appliance if there is visible damage to the appliance or the connecting cable, or if the appliance has previously been dropped
Only connect the plug to a properly installed, easily accessible, earthed socket whose voltage is
DANGER of electric shock!
Do not operate the appliance if there is visible damage to the appliance or the connecting cable or if the appliance has previously been dropped.
Only connect the plug to a properly installed, easily accessible, earthed socket whose voltage corresponds to the data on the rating plate. The
socket must remain easily accessible even after connection.
Make sure that the connection cord cannot be damaged by sharp edges or hot spots.
The power supply to the appliance is not completely interrupted even after switching it off. To do so, pull the plug out of the socket.
When using the appliance, make sure that the connecting cable is not pinched or trapped.
To avoid dangerous situations, do not make any changes to the appliance.
Always pull the plug out of the socket by the plug and never by the cable.
Pull the plug out of the socket
- When a malfunction occurs
- When you are not using the appliance,
- Before cleaning the appliance
- During thunderstorms
DANGER to burn injuries!
Do not touch the hot parts of the appliance
Introduction
Read this manual carefully before using the appliance so that you can use it correctly.
Observe this manual carefully.
CAUTION:
The heating element must not be located directly under a wall socket.
The heating system must be installed at least 1.8 m above the floor.
Never place the heating system above or less than 1.5 m from a bath, shower, toilet or other water supply.
Provisions for disconnection with contact separation in all poles must be provided in the fixed wiring, in accordance with wiring regulations.
Use:
1. Check before use:
A: The heating element and electric wire must not be broken
B: Do not use sockets of less than 10A
Installation:
Drill two holes in the wall at a distance of 1.8 m from the ground. The diameter of the drill is the diameter of the opening of the plug provided. After drilling
the hole, insert the plug into the drilled hole and screw in the screws.
Make sure the hook is tight and hang the heater. The clip under the hook should be inserted into the rebate of the bottom of the heater.