I N STA L L ATION OF THE SUPERDISK DEVICE DRIVER FOR WINDOWS 98
This Device Driver software must be installed into your host computer before operating
the SuperDisk drive.
1. Turn on the personal computer and start Windows 98.
2. Set the SuperDisk driver disc in your CD-ROM drive.
3. Open the Run… window from the Start menu.
4. Type "A:\SETUP.EXE" and press OK. (assumes that your drive is designated "A")
5. Follow the procedures displayed on the screen to install SuperDisk Device Driver.
I N STA L L ATION OF THE SUPERDISK DEVICE DRIVER FOR MAC OS
This Device Driver software must be installed into your host computer before operating
the SuperDisk drive.
1. Turn on your Macintosh computer.
2. Set the SuperDisk driver disc in your CD-ROM drive.
3. Double-click the "SuperDisk Installer CD" icon displayed on desktop.
4. Double-click the "SuperDisk Installer" icon in the opened "SuperDisk Installer CD”.
5. Follow the procedures displayed on the screen to install SuperDisk Device Driver.
Note : The 32MB FD writing software "SuperWriter32” is installed along with the above
installation. Once you have formatted a 1.44MB floppy diskette as 32MB with the
"SuperWriter32" software, it may be read and accessed only with a LS240 SuperDisk
drive that is connected to a system that has the "SuperWriter32" software installed on it.
Note: Please refer to Que! Super Disk 240 Installation Manual CD for complete installation version.
8
W I N D O WS/MAC INSTA L L AT I O N
To Next Page
Loading...
Need help?
General