To Next Page

To Previous Page

I N STA L L AT I O N S

To Start Operation on Drive.

1. Turn on the power supply of the Host PC.

2. Plug the USB interface cable of the SuperDisk

drive to Host PC USB port. (Refer the previous page)

3. Insert a disk into the disk slot with the disk’s label

facing up and the shutter side heading as shown in

the below figure.

CAUTION:

• Do not insert any foreign objects into the disk slot. This could result in a malfunction.

• Do not press down hard on a disk when inserting the disk, because this may cause

damages or malfunction to the disk and/or the drive unit.

• In case of emergency, eject the disk manually If for some reason the disk does not e j e c t

automatically, press the eject-bar (for example, insert a straightened paper clip pin with

minimum straight length = 15 mm, diameter = 0.5 ~ 0.8 mm) into the

emergency eject hole to eject the disk. (Before proceeding with this

emergency step, make sure that the power is switched OFF.)

Note: Please refer to Que! Super Disk 240 Installation Manual CD for complete installation version.

GUIDE TO OPERAT I O N

Questions and Answers:

Need help?

Do you have a question about the QPS SUPER DISK Que! and is the answer not in the manual?

QPS SUPER DISK Que! Specifications

General