RD: Set negative RIT offset amount
Set: Sets negative (down) RIT; for example “RD-200;” sets the RIT to -200Hz
RT: Get RIT status
Get: Returns RIT status: 0 = RIT off, 1 = RIT on
RU: Set positive RIT offset amount
Set: Sets positive (up) RIT; for example “RD150;” sets the RIT to 150Hz
RX: Set the radio into Receive mode immediately
Set: Command RX; immediately puts the radio into receive mode. It is equivalent to TQ0;
SP: Get/Set Split mode
Set: Sets Split mode: 0 = OFF, 1 = ON. For example “SP1;” switches QDX to split mode
Get: Returns the Split state: 0 = OFF, 1 = ON.
TQ: Get/Set transmit state
Set: Sets transmit state: 0 = RX, 1 = TX. For example “TQ1;” switches QDX to transmit mode
Get: Returns the transmit state: 0 = RX, 1 = TX.
TX: Set the radio into Transmit mode immediately
Set: Command TX; immediately puts the radio into transmit mode. It is equivalent to TQ1;
31