3
TD-001536-01-B
Maintenance and Repair
WARNING: Advanced technology—e.g., the use of modern materials and powerful electronics—requires specially
adapted maintenance and repair methods. To avoid subsequent damage to the equipment, personal injury, and/or creation
of additional safety hazards, have all maintenance or repair work on the equipment performed only by a QSC authorized
service center or an authorized QSC International Distributor. QSC is not responsible for any injury, harm, or related
damages that arise from any failure of the customer, owner, or user of the equipment to facilitate those repairs.
Life Cycle: 10 years Storage Temperature range: -20° C to +70° C Relative Humidity range: 5 - 85% RH
FCC Statement
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
RoHS Statements
These products are in compliance with “China RoHS” directives per GB/T26572. The following table is provided for
product use in China and its territories:
The KS112, KS118 and KS212C 这些产品
部件名称
(Part Name)
有害物质
(Hazardous Substances)
铅
(Pb)
汞
(Hg)
镉
(Cd)
六价铬
(Cr(vi))
多溴联苯
(PBB)
多溴二苯醚
(PBDE)
电路板组件
(PCB Assemblies)
X O O O O O
机壳装配件
(Chassis Assemblies)
X O O O O O
本表格依据 SJ/T 11364 的规定编制。(This table is prepared following the requirement of SJ/T 11364.)
O: 表示该有害物质在该部件所有均质材料中的含量均在 GB/T 26572 规定的限量要求以下。
O: Indicates that the concentration of the substance in all homogeneous materials of the part is below the relevant threshold specied in
GB/T 26572.
X: 表示该有害物质至少在该部件的某一均质材料中的含量超出 GB/T 26572 规定的限量要求。
X: Indicates that the concentration of the substance in at least one of all homogeneous materials of the part is above the relevant threshold
specied in GB/T 26572.
（目前由于技术或经济的原因暂时无法实现替代或减量化) (Replacement and reduction of content cannot be achieved currently because of the
technical or economic reason.)
To Next Page
Loading...
Need help?
General
Weight and Dimensions
