QSC NS Series 09/27/2020 4
Technical Notes:
QSC NS Series Firmware and Technical Guide
a. Open a web browser and type in the IP address
of the switch.
b. Use the default login credentials (if still applicable).
c. Navigate to SYSTEM > GENERAL > CLI Banner.
d. Scroll down to the MESSAGE OF THE DAY
CONFIGURATION section and verify that “switch”
configuration version is v1.6.0. appears in the
BANNER field:
Verifying the v1.6.0 Configuration
d.
h. Confirm the file transfer operation completed
successfully under Transfer Status:
i. Click Save in the upper right and click “OK’ on the
resulting prompt:
j. Manually power cycle the switch.
h.
i.
To Next Page
Loading...
General