What to do if the motor doesn't respond on my Quadrone Drone and the LED flashes?
If the motor of your Quadrone Drone doesn't respond and the LED flashes, it's likely the helicopter battery is drained. Ensure you fully charge the batteries.
What to do if my Quadrone Drone has no response after connecting the battery?
If your Quadrone Drone doesn't respond after connecting the battery, it could be due to several reasons: 1. Check if the remote is turned on and the drone battery is properly inserted. 2. The battery power might be low, so ensure you charge the battery. 3. There might be poor contact on the battery terminals; try re-seating the batteries properly.
Why does the main rotor continue to spin after landing my Quadrone Drone?
If the main rotor of your Quadrone Drone continues to spin after landing, it's possible the throttle trim was accidentally increased during flight. Make sure the throttle trim is in the center or slightly below.
How to fix Quadcopter LED blinking with no response to the remote controller on Quadrone Drones?
If the Quadcopter LED blinks for more than 4 seconds after inserting the battery and there's no response to the remote controller, it means the quadcopter and remote are unable to sync. You should repeat the syncing process.
Follow all instructions and warnings for safe handling, charging, and usage of Li-po batteries.
Use only the supplied charger compatible with Li-po batteries to prevent damage and injury.
Place the quadcopter on a flat surface, insert the battery, and plug it in; LED lights will flash.
To Next Page
General
