6
1. Pick up the handset, then press *
STORE
key for 3 seconds until you hear a “di” tone.
2. Enter the phone number you wish to store using the dial pad.
3. Press the MEMORY key.
4. Press one of numerical keys (0, 1, 2, …, 9) on the dial pad to store the number under that chosen key.
¾ Make a call from two-touch memory
1. Pick up the handset, press the MEMORY key and then press the numerical key on the dial pad where under the
desired number was stored (0, 1, 2, …, 9).
2. The stored number is now dialed out.
FLASH FUNCTION
The flash function can be used behind a PABX when transferring a call to another extension. Press the flash key
followed by the extension number. Normally the flash time should be adjusted to 100ms by setting the flash slide
switch at the back of the phone to 100.
MUTE FUNCTION
During a conversation press and hold the mute key. The other party will not be able to hear your conversation. To
restore two-way conversation, release the mute key.
PAUSE
When dialing, press the REDIAL/P button to insert a 3.6s pause time between digits. This function is used behind a
PABX. Insert the PAUSE between the PABX access digit (usually 0 or 9) and the number to be dialed. Use this
function when you want to redial a number or when you store a number in memory.
P-T SWITCH
Adjust the MODE switch at the back of the phone to T for Tone dialing or P for Pulse dialing. Normally this switch
should be set to T.
ADJUSTING RINGER VOLUME
Slide the RINGER switch to HI (High) or MID (Middle) or LO (Low) to adjust the ringer volume.
ADJUSTING HANDSET VOLUME
Slide the VOLUME switch to HI (High) or MID (Middle) or LO (Low) to adjust the handset volume.
LOCK
Turn the key at the bottom of the phone to:
1) RED – Then the keypad is active and all numbers may be dialed.
To Next Page
