Maintenance
1. WASHING FRYER VAT
To wash the vat, one must follow the oil ltering steps explained in the
“Daily” chapter, without pouring the oil into the vat once again.
- Open the appliance door.
- Unscrew the connector, then pull it carefully.
- Loosen the wheel of the extraction coupling, raise the coupling and
tighten the wheel again so that it stays up.
- Pull the handle, located in the lower left part of the appliance, to
release the fryer case and to remove it from the machine.
- Remove the fryer cover by removing the four (4) latches located on
Use personal protection equipment (anti-cut gloves for work with
steel or sheet metal and protective gloves or utensils against
chemical agents) as mentioned in the Safety section.
Weekly or every 200 product portions
60QUALITYFRY 60QUALITYFRY
To Next Page
Loading...