Item Description
Event log category Select one of the following event categories:
All Event Logs
Sensor-Specific Events
BIOS Generated Events
System Management Software Events
Refresh Click to refresh this table.
Clear Event Log Left Click the button to clear the all event logs.
Configuration
The Configuration tab enables you to access various configuration settings, including Alerts, Mouse Mode, Network, SOL,
SNMP, SMTP, Users, PEF, SSL, Web Session and Power Protection settings. Click the Configuration tab to view the
following web page.
Alerts
When BMC sends a platform event, such as an environment warning or a component failure, an alert message may be sent to
one or more email addresses / IP addresses. On this page, you can configure an alert destination. To delete an alert
configuration entry, select it and click Delete button. To create a new alert configuration entry, select a Destination Address
that has not been configured yet from the alert table and click Modify button.
Chapter 5 — ESMS
123
Configuration web page
To Next Page
Loading...
