Appendix A — Support
Installing the Rack Brackets
When the server is to be installed into a rack, it is necessary to install two rack mount brackets onto the server
chassis prior to installing the server into the rack. Follow the procedures below to install the rack mount brackets
onto the server.
Remove the Rails
1. Loosen the four securing screws from the slider mechanism.
2.
3.
Extend the front and rear ends of the rails to fit the rack cabinet.
Secure with all necessary screws for your cabinet.
4.
Tighten the four screws on the slide rails to secure in place.
154
To Next Page
Loading...
