Chapter 2 — Installing Hardware
Installing Heat Sinks
WARNING!
If the server board is to be operated with only a single processor, both heat sinks must be
installed to insure proper cooling.
Refer to the following instructions to install heat sinks:
1.
2.
3.
Apply thermal compound evenly on the top of the CPU.
Remove the protective cover from the underside of the heat sink.
Place the heat sink(s) on top of the CPU and tighten the four (per heat sink) captive screws.
4. Tighten the four retaining screws clockwise, in the order shown, to secure the heat sink.
5. Repeat steps 1 through 4 for the second heat sink.
15
To Next Page
Loading...
