Chapter 2 — Installing Hardware
Installing Memory
The mainboard has eighteen DDR3-DIMM slots for the installation of up to twelve un-buffered DIMMs @ DDR3
800/1066/1333 MHz or eighteen registered DIMM memory sockets with ECC. Refer to QSSC-S99K 2U Mainboard Com-
ponents on page 2 for the location of the memory modules.
Refer to the following instructions to install memory modules:
1.
2.
Pull the locking latches of the DIMM slot outwards.
Align the memory module correctly. Note the notch and obstruction in the following illustration.
3. Press the edge connector of the memory module into the slot. Press down firmly so that the locking
latches of the DIMM slot are levered upwards to secure the memory module in place.
18
To Next Page
Loading...
