QUANTA QSSC-S99K 2U - Page 56

Remote Access Configuration









*1: Disabled/Enabled
*2: COM1/COM2
*3: 115200 8,n,1/57600 8,n,1/38400 8,n,1/19200 8,n,1/09600 8,n,1
*4: None/Hardware/Software
*5: Disabled/Enabled
*6: ANSI/VT100/VT-UTF8
Limitation: When populate serial device, the remote access function must be disabled.
Control Group User Access Level
Remote Access Access Level 2
Serial port number Access Level 2
Serial Port Mode Access Level 2
Flow Control Access Level 2
Redirection After BIOS POST Access Level 2
Terminal Type Access Level 2

View BMC System Event Log
Chapter 3 — BIOS
48
Select Remote Access
type.
← Select Screen
↑↓ Select Item
-+ Change Option
F1 General Help
F10 Save and Exit
ESC Exit
Configure Remote Access type and parameters
----------------------------------------------------
Remote Access [Enabled]*1
Serial port number [COM1]*2
Current SOL Baud Rate 115200 bps
Serial Port Mode [115200 8,n,1]*3
Flow Control [None]*4
Redirection After BIOS POST [Enabled]*5
Terminal Type [ANSI]*6
Server
BIOS Setup Utility
v02.66
©
Co
py
ri
g
ht 1985-2009, American Me
g
atrends, Inc.
Use +/- to traverse
The event log.
← Select Screen
↑↓ Select Item
-+ Change Option
F1 General Help
F10 Save and Exit
ESC Exit
Total Number Of Ent
r
ies: 84
----------------------------------------------------
SEL Entry Number [1]
SEL Record ID: 0001
SEL Record Type 02(System Event)
Event Timestamp: 48s from SEL init
Generator ID: 0020
Event Message Format Ver: 04 (IPMI ver 2.0)
Event Sensor Type 14 (Button)
Event Sensor Number: D3
Event Dir Type: 6F
Event Data: 00 00 00
- Power Button pressed
- N/A
- N/A
Server
BIOS Setup Utility
v02.66
©
Co
py
ri
g
ht 1985-2009, American Me
g
atrends, Inc.