Error Code Error Message Response
0164 Processor missing microcode Pause
0165 Processor missing microcode Pause
0166 Processor missing microcode Pause
0167 Processor missing microcode Pause
0180 BIOS does not support current stepping Pause
0181 BIOS does not support current stepping Pause
0182 BIOS does not support current stepping Pause
0183 BIOS does not support current stepping Pause
0184 BIOS does not support current stepping Pause
0185 BIOS does not support current stepping Pause
0186 BIOS does not support current stepping Pause
0187 BIOS does not support current stepping Pause
0194 CPUID, Processor family are different Halt
0196 CPUID, Processor Model are different Halt
0193 CPUID, Processor stepping are different Halt
0192 L2 cache size mismatch Halt
0197 Processor speeds mismatched Halt
0198 Processor Mismatch Halt
5120 Cmos cleared by jumper Pause
5121 Password cleared by jumper Pause
5125 Not enough space to copy PCI Option ROM Pause
8101 Warning! USB Host Controller not found at the specified address!!! Warning
8102 Error! USB device failed to initialize!!! Warning
8103 Warning! Unsupported UBS device found and disabled!!! Warning
8104
Warning! Port 60h/64h emulation is not supported by this USB Host
Warning
8105 Warning! EHCI controller disabled. It requires 64bit data support in the BIOS. Pause
8301 Not enough space in Runtime area! SMBIOS data will not be available. Warning
8302 Not enough space in Runtime area! SMBIOS data will not be available. Pause
8601 Error: BMC Not Responding Pause
8701
Insufficient Runtime space for MPS data. System may operate in PCI or
Non-MPS mode.
Pause
[9] If the ID LED is blinking before the system being turned off, the ID LED would be turned off after the system
is being powered off. But it can still being turned on in DC off state.
Chapter 4 — BMC
68
To Next Page
Loading...
