Chapter 1 — Introduction
Chapter 1
Introduction
The QSSC-S99K 2U server system features a motherboard with two FC-LGA1366 socket that accommodate single or dual
Intel® Xeon Nehalem-EP processors, and features the Tylersburg-EP-2S/ICH10R chipsets.
Eighteen DDR3 registered DIMM slots enable you to add up to 144 GB of total memory. ECC support provides extra
security against system failure. Six Serial ATA II (SATAII) ports and four optional Serial Attached SCSI 6Gbp/s ports
provide maximum flexibility in installing hard drives.
The QSSC-S99K 2U has a full range of I/O ports, including two USB ports, two 10/100/1000 Gigabit Ethernet LAN ports, one
link from ICH10R+82576, one 10/100M LAN port from AST2050, one 9-pin serial port, and one 15-pin VGA port.
ASPEED 2050 server management firmware enables the administrator to monitor the QSSC-S99K 2U status through a typical
web browser.
Checklist
Carefully unpack the QSSC-S99K 2U and check that the following items are included.
One QSSC-S99K 2U chassis
One single power supply or a set of redundant power supplies
One CPU heat sink for a single CPU order, two CPU heat sinks for a dual CPU order
One set of rack mount rails
User manual
One utility CD with support software drivers
Contact your vendor if some items are missing or appear damaged.
1
To Next Page
Loading...
