PEF/PET Alerting Commands
Command NetFn CMD O/M Supported?
Get PEF Capabilities S/E 10h M Yes No
Arm PEF Postpone Timer S/E 11h M Yes No
Set PEF Configuration Parameters S/E 12h M Yes No
Get PEF Configuration Parameters S/E 13h M Yes No
Set Last Processed Event ID S/E 14h M Yes No
Get Last Processed Event ID S/E 15h M Yes No
Alert Immediate S/E 16h M Yes No
PET Acknowledge S/E 17h M Yes No
PEF Configuration Parameters
Parameter # Parameter Data (non-volatile otherwise noted)
Set In Process 0 Byte 1 – This bit
[7:2] – Reserved
[1:0] – 00b Set Complete
01b Set In Process
10b Reserved
11b Reserved
PEF Control 1 Byte 1
[7:4] Reserved
[3] Reserved
[2] Reserved
[1] 1b Enable event message for PEF actions
[0] 1b Enable PEF
PEF Action Global Control 2 Byte 1
[7:6] Reserved
[5] 1b Enable diagnostic interrupt, NMI in this platform
[4] Reserved
[3] 1b Enable Power Cycle
[2] Reserved
[1] 1b Enable Power Down
[0] 1b Enable Alert
Number of Event Filter 5 Byte 1
[7] Reserved
[6:0] 16 Event Filter Entry support in default platform
Event Filter Table 6 Byte 1 Set Selector
[7] Reserved
[6:0] Filter number 1 base
Byte 2:21 Filter Data
Chapter 4 — BMC
85
To Next Page
Loading...
