10
5.3.2.13 Press Program and Down-arrow at the same time:
This enters the setpoint-programming mode.
Display toggles between [SP_1] and [50000]. 18.xxx for the new model
5.3.2.14 Press the Program button repeatedly until the
Display toggles between [SP_5] and [30000],10000 for the new model.
Change SP_5 to 1.000
Note: If SP_5 is unavailable, perform the next step (SPC_5) then come back
to this step; Ensure SPC_5 is set to [000].
You should now be able to set up SP_5 to 1.000. Continue and perform the
next step before locking the meter.
5.3.2.15 Press Program button repeatedly until the
Display toggles between [SPC_5] and [000].
Change SPC_5 to 46.
5.3.2.16 Check all the setting before lock
STEP B LOCK CODE SETUP:
5.3.2.17 Loosen the meter from cabinet.
5.3.2.18 Remove black face meter bezel.
5.3.2.18 Set both DIP Switches from OFF to ON position.
5.3.2.20 Reinstall the bezel and secure the meter.
To Next Page
Loading...