Need help?Do you have a question about the Quantum Audio Solar QS1500D and is the answer not in the manual?
General| Channels | 1 |
|---|---|
| Peak Power | 3000W |
| Bass Boost Frequency | 45Hz |
| RMS Power at 4 Ohms | 500W |
| RMS Power at 1 Ohm | 1500W |
| Input Sensitivity | 0.2V - 6V |
| Subsonic Filter | 10Hz |
| Bass Boost | 0dB |
Attach sales receipt for warranty service needs.
Proper installation maximizes system performance.
Fuse power wire within 12" of battery for protection.
Use high grade connectors for maximum power transfer.
Run wires inside vehicle to prevent damage.
Be aware of vehicle components when mounting.
Route signal wires away from electrical wires to prevent noise.
Make ground wires short and connect at one point.
Protect wires from sharp edges to prevent shorts.
Protects speakers from DC voltage by shutting down the amplifier.
Protects amplifier from damage due to speaker shorts.
Shuts down amplifier if it overheats, restarts when cooled.
LED indicates power status (green) or protection mode (red).
Features variable high and low pass crossovers for frequency filtering.
Provides 0-12dB bass boost at 45Hz.
Lists speaker impedance stability for stereo and bridged modes.
Use appropriate gauge wire and in-line fuse for battery connection.
Ensure clean, tight ground connection to the vehicle chassis.
Connect to head unit's remote output for auto turn-on/off.
High-level input wiring for floating ground radios.
High-level input wiring for common ground radios.
High-level input wiring for floating ground radios.
High-level input wiring for common ground radios.
Addresses blown fuses, bad cables, and connection problems.
Covers level adjustments, cable issues, and level matching.
Details grounding, cable quality, and charging system checks.
Troubleshooting speaker shorts, impedance, and overheating.
To Next Page
