15
Positioning Belt
Your power chair may be equipped with a positioning belt
that can be adjusted for operator comfort. See figure 13. The
positioning belt is designed to support the operator so that he/
she does not slide down or forward in the seat. The positioning
belt is not designed for use as a restraining device.
The positioning belt is not designed for use as a seat belt
in a motor vehicle. Anyone traveling in a vehicle should
be properly belted into seats approved by the vehicle
manufacturer. Your power chair is not suitable for use as
a seat in any vehicle with the following exception: The
vehicle must be equipped with a Wheelchair Tie-down
and Occupant Restraint System (WTORS) that has been
installed in accordance with the tie-down manufacturer's
instructions, and is compliant with ANSI/RESNA WC/Vol.
4, Section 18/ISO 10542 standards, and the power chair
must have a transit securement system conforming
to ANSI/RESNA WC/Vol. 4, Section 19/ISO 7176-19
standards. It is essential to use a complete WTORS to
secure the power chair to the vehicle and to provide
the power chair occupant with a properly designed
and tested safety restraint system. A restraint system
with both pelvic and upper-torso belts must be used
to protect the power chair occupant and minimize the
likelihood of injury caused by contact with the vehicle
during a crash or sudden braking.
The positioning belt should be secured at all times.
Never allow the positioning belt to hang or drag on the
floor as it may become entangled.
To install the positioning belt:
1. Remove the rearmost screw that holds the seat hinge to
the seat base on both the left and right seat hinges.
2. Insert the screw through the supplied washer, through
the positioning belt and into the seat base for each side
of the power chair seat.
3. Tighten both screws.
To adjust the positioning belt for operator comfort:
1. Once seated, insert the metal tab on one side of the belt
into the plastic housing on the opposite side until you
hear a click. See figure 13.
2. Pull the excess strap attached to the metal tab until it is
secure, but not so tight as to cause discomfort.
To release the positioning belt:
1. Press the push button mechanism on the plastic housing.
Make sure the positioning belt is properly secured to the
power chair and is adjusted for operator comfort before
each use.
Inspect the positioning belt for loose parts or damage,
including tears, worn spots, bent hardware, damaged
latch mechanisms, dirt or debris, before each use of
the power chair. If you discover a problem, contact your
Quantum Rehab Provider for maintenance and repair.
Figure 13. Positioning Belt Adjustment
MANDATORY!
WARNING!
COMFORT ADJUSTMENTS
To Next Page
Loading...
Need help?
General
